
Description
Protects edge network devices, including PoE cameras and LAN access points, from power surges, ESD and cable discharge events.
Outdoor In-Line Surge Protector for 1G PoE Edge Network Equipment Safe Ideal for home or corporate security systems, wireless access points, routers, bridges and other PoE (Power over Ethernet) applications, the device protects outdoor-mounted network equipment from damage caused by power surges and electrostatic discharge (ESD).
Connect between your source and network equipment using standard 23/24 AWG Cat5e/6/6a cables through the included cable glands. Both mid-span and end-point PoE are supported.
Thyristor diode type technology features low impedance and superior power handling capabilities, providing protection against ESD with a super-fast response time under one nanosecond. Gas discharge modules on all four twisted pairs protect each wire from surges or spikes by dissipating the voltage transient through a contained plasma gas.
Line-to-line and line-to-ground protection modes help protect against short circuits and minimize distortion of high-speed signals.
The device complies to the following IEC regulations: IEC 61000-4-2 (ESD) +/- 15kV (Air), +/- 8kV (Contact) and IEC 61000-4-5 10kA (8/20µs), 20kV (8/20µs).
Easy to install with housing allowing for pole mount clamps.
Features
- High discharge capacity, low voltage protection level
- Quick response, high transmission speed, low signal attenuation
- Suitable for outdoor application, IP65 Rated
- RJ45 connection, easy installation
Specification
Nominal voltage | UN | 48V- |
DC spark-over voltage (at 100V/s) | UDC spark | 90V- |
Max. impulse spark-over voltage (at 1kV/µs) | Umax. spark | 700V |
Nominal discharge current (8/20µs) | In | 1 ,5kA |
Total nominal discharge current (8/20µs) | Itotal | 5kV |
Voltage protection level | Up | 600V |
Max. insulation resistance (at 50V) | R | IG ohm |
Max. capacitance (at 1MHz) | C | 1.0 PF |
Max. data transmission rates | Vs | 1000Mbit/s |
Operating temperature range | -35 to +65°C | |
Connection input / output | RJ45 socket | |
Waterproof rating | IP 65 | |
Earthing via | Screw terminal | |
Mounting on | Metal clip or screws | |
Enclosure material | Thermoplastic | |
Test standards | IEC 61643-21; EN 61643-21 | |
Certification | CE (LVD); RoHS |
Installation
Note: Ensure that the inlet and outlet cable do not follow the same route as this could cause signal interference




Ordering Information
NLPoEETHG-IL-1P-OD | Outdoor PoE Gigabit Fast Ethernet Inline Protector with low insertion loss, , 5/60V, 8 lines, 250 Mbits/s, Imax 2KA/40A at 8/20us, 100Base-T and 1000Base-T and IEEE 802.3u and IEEE 802.3 at/af compliant |